Emergency furnace repair in Severance: what to do first

If your furnace dies in Severance, the first thing to do is make sure everyone is safe: check that the thermostat is actually calling for heat, confirm the furnace switch and breaker are on, and if you smell gas, leave the house and call 911 before anything else. Then call a furnace tech - do not keep resetting the unit hoping it catches. Emergency furnace repair in Severance CO is a same-day call for us, and in most cases we can have heat back on within a few hours of your call. The rest of this guide walks you through the exact order of steps, what a real emergency looks like versus a nuisance shutdown, and what 2026 pricing looks like in this part of Weld County.

What to do first when your furnace dies in Severance

Emergency furnace repair in Severance CO is the service of getting a failed heating system diagnosed and running again outside normal business hours - nights, weekends, and holidays - when the indoor temperature is dropping and you cannot wait until Monday. The order of operations matters more than the speed. Here is how we tell homeowners to handle the first ten minutes.

1. Check for gas smell. If you smell rotten eggs or sulfur, do not touch light switches. Get everyone outside and call 911 and the gas utility. This is not a repair call, it is an emergency.
2. Confirm the thermostat is set to Heat and the setpoint is at least 3 degrees above the current room temperature. A thermostat bumped to 62 when the room is 64 will not fire the furnace.
3. Check the furnace switch. There is a standard light-switch-style power switch on or near the furnace - usually on the side of the unit or on the wall within a few feet. Make sure it is up.
4. Check the breaker. A furnace on a dedicated 15- or 20-amp circuit that has tripped will look completely dead. Reset it once. If it trips again, stop and call us.
5. Check the filter. A filter that is fully clogged with dust and pet hair will trip the high-limit switch and shut the furnace down. If it looks grey and matted, swap it.
6. Look at the LED error code on the control board behind the lower access panel. Modern furnaces flash a code - three flashes, four flashes, etc. Write it down. That code saves us 20 minutes on the diagnostic.

If none of that brings heat back, stop. Do not keep flipping the breaker or cycling the reset. Call us and we will dispatch a tech. If you want the full picture of what we do on arrival, our Emergency Furnace Repair Severance CO page covers the diagnostic sequence we run on every no-heat call.

How to tell a real emergency from a nuisance shutdown

Not every no-heat call is a true emergency. About a third of the calls we run in Severance turn out to be something a homeowner could have handled - a tripped switch, a dead thermostat battery, a filter so clogged the furnace locked itself out. The other two-thirds are real: failed igniters, cracked heat exchangers, dead blower motors, control boards that have given up.

Here is the rough split we see on service calls across Severance, Windsor, and Eaton:

• Igniter or flame sensor failure - the most common no-heat call. Furnace tries to light, you hear clicking, then it shuts off. Usually a $180-$420 repair in 2026.
• Blower motor failure - furnace lights, gets hot, then shuts down because the blower is not moving air. Often $450-$900 depending on motor type.
• Control board failure - no lights, no fan, no nothing. $500-$1,100 in parts and labor.
• Thermostat or wiring issue - furnace is fine, the signal never arrives. Usually under $250.
• Heat exchanger crack - the one you cannot ignore. This is a carbon monoxide risk and often pushes toward replacement rather than repair.

If your CO detector is going off, or anyone in the house has a headache, nausea, or unusual drowsiness, get out and call 911. Do not wait for a tech.

What should I do first for emergency furnace repair in Severance CO?

Call a licensed furnace tech before you start pulling panels - the first move is a phone call, not a repair. The reason is simple: the two failure modes that actually hurt people, gas leaks and cracked heat exchangers, look identical to a dead igniter from the outside. A tech on the phone can triage in 60 seconds and tell you whether to evacuate or just wait.

While you wait, do these three things:

• Protect pipes. Open cabinet doors under sinks on exterior walls. If the outdoor temp is below 20°F and the house is dropping fast, let a pencil-thin stream of water run from the furthest faucet.
• Consolidate the household. Move everyone into one room, close doors, and use space heaters - but only on a circuit that is not already loaded, and never unattended.
• Write down what you saw. Error codes, sounds, smells, when it stopped. That information is worth real money on the diagnostic.

We handle everything from a Furnace Ignition Repair Severance CO call to a full control board swap, and we carry the common igniters, flame sensors, and boards for Carrier, Trane, Goodman, and Rheem on the truck. That is why most no-heat calls in Severance get fixed on the first visit instead of turning into a two-trip job.

Who offers 24 hour furnace repair in Severance

Severance Furnace Repair Pros runs 24 hour furnace repair in Severance, including nights, weekends, and holidays. We are a local shop - our techs live in this corridor, not in Denver or Greeley - so dispatch times stay short even on the coldest nights of the year.

If you have been searching "24 hour furnace repair near me Severance" at 11 p.m., here is what you should expect from any shop you call:

• A live person or a callback within 15 minutes, not a voicemail box.
• A clear after-hours rate quoted before the tech rolls.
• A licensed, insured technician - ask for the license type, not just a name.
• An ETA in minutes, not "sometime tonight."

We also serve the surrounding towns, and a lot of our after-hours calls come from just over the county line. If you are in Furnace Repair in Windsor or the surrounding communities, the same dispatch line covers you.

How fast can a furnace tech get to Severance Colorado?

From our dispatch point, a tech can typically reach most Severance addresses in 30 to 60 minutes during normal hours and 45 to 90 minutes after hours. Severance is a small town - most of it sits within a few minutes of Highway 392 - so drive time is rarely the bottleneck. What slows things down is call volume on the first hard freeze of the season, when every shop in Weld County is running flat out.

A few things that affect how fast we get to you:

• Time of day. 6 p.m. to 10 p.m. on a cold night is the busiest window of the year.
• Weather. Ice on I-25 and Highway 257 adds real minutes. We plan for it.
• Whether you call or text. A call gets triaged faster than a text, every time.
• How clearly you describe the problem. "No heat, error code 3-3, Goodman furnace" gets a faster dispatch than "furnace broken."

If you are comparing us to a bigger Front Range company, remember that a shop driving up from Denver is adding 45 minutes each way to your bill and your wait. Local matters on a no-heat night.

What to do if your furnace stops at night in Severance

If your furnace stops at night in Severance, call us - do not wait until morning. Overnight lows in this part of Colorado routinely drop into the teens and single digits from December through February, and a house can lose 8 to 12 degrees of indoor temperature in the first two hours after the heat stops. By 6 a.m. you are looking at frozen pipes, not just a cold morning.

While you wait for the tech, here is the overnight playbook:

1. Set the thermostat fan switch to ON instead of AUTO. That circulates air through the filter even if the burner is not firing, which keeps some heat moving.
2. Run the fireplace if you have one, but crack a window an inch for ventilation.
3. Do not run a gas oven for heat. It is a carbon monoxide risk and it is how people die in winter.
4. If you have a generator, do not plug a space heater into it unless the generator is rated for the load. Most portable units are not.
5. Check on elderly neighbors. In a small town, that is just what we do.

We run overnight calls all winter. If you are not sure whether your situation is worth a middle-of-the-night dispatch, call anyway - we will tell you honestly whether it can wait until morning.

Common mistakes homeowners make during a furnace emergency

The mistakes we see most often on emergency calls in Severance are the ones that turn a $300 repair into a $3,000 replacement. Here is what to avoid.

• Resetting the furnace over and over. If it locks out three times in a row, something is wrong. Repeated resets can flood the combustion chamber with gas and shorten the life of the igniter.
• Pulling the panel and poking around. There is a 120-volt circuit inside the furnace cabinet. Capacitors hold a charge even after power is off.
• Running a space heater on an extension cord. That is the number one cause of house fires we see in cold snaps. Plug heaters directly into a wall outlet.
• Ignoring a CO detector. If it chirps once and stops, replace the battery and test it. If it alarms, get out.
• Calling three shops at once. You will end up with two techs on your driveway and a cancellation fee. Call one, wait for the ETA, then decide.
• Choosing a repair when replacement is the right call. A furnace over 18 years old with a cracked heat exchanger is not worth a $1,200 repair. Our Furnace Repair Cost Severance CO guide breaks down the repair-versus-replace math.

When to call a professional

Call a professional the moment you smell gas, hear a boom or rumble on ignition, see soot or scorch marks around the furnace, or get a CO alarm. Those are not DIY problems. Call us on those, and call us on the ones that just will not fire after you have checked the switch, breaker, filter, and thermostat.

Severance Furnace Repair Pros handles emergency furnace repair, gas and electric furnace diagnostics, blower motor and control board replacement, and safety inspections across Severance and the surrounding Weld County towns. We quote the repair price before we start work, and we tell you when a repair is not worth doing. If you want to know what a routine visit looks like when nothing is broken, our Furnace Maintenance Severance CO page covers the annual tune-up we recommend every fall.

Frequently Asked Questions

What should I do first for emergency furnace repair in Severance CO?

Check for a gas smell first - if you smell gas, leave and call 911. Otherwise confirm the thermostat is set to Heat, the furnace switch is on, and the breaker has not tripped. Then call a licensed tech. Do not keep resetting the furnace.

Who offers 24 hour furnace repair in Severance?

Severance Furnace Repair Pros runs 24 hour furnace repair in Severance, including nights, weekends, and holidays. We are a local shop, so dispatch times stay short even on the coldest nights. Call and you will get a live person or a callback within 15 minutes.

How fast can a furnace tech get to Severance Colorado?

Typically 30 to 60 minutes during normal hours and 45 to 90 minutes after hours. Severance is a small town close to Highway 392, so drive time is short. First hard freeze of the season is the slowest window because every shop is busy.

What to do if furnace stops at night in Severance?

Call us - do not wait until morning. Overnight lows here drop into the teens and single digits, and a house can lose 8 to 12 degrees in the first two hours. Set the thermostat fan to ON, use the fireplace if you have one, and never run a gas oven for heat.

How much does emergency furnace repair cost in Severance in 2026?

Typical 2026 emergency furnace repair in Severance runs $180 to $420 for an igniter or flame sensor, $450 to $900 for a blower motor, and $500 to $1,100 for a control board. After-hours calls add a dispatch fee, usually $75 to $150.

Get help with Furnace Repair in Severance

If your furnace is down and the house is getting cold, call us now - we run emergency calls in Severance 24 hours a day, and we will tell you straight what is wrong and what it costs to fix. One call, one tech, heat back on.

Call Severance Furnace Repair Pros at (970) 1234567.